pub:installation_for_idocs_6.x
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
pub:installation_for_idocs_6.x [2018/03/31 10:39] – [Step 3. Complete the Installation on the Power System] ken | pub:installation_for_idocs_6.x [2018/06/15 18:50] – [Step 3. Complete the Installation on the Power System] kkramer | ||
---|---|---|---|
Line 115: | Line 115: | ||
Then place the new library on the first position on your library list: \\ **ADDLIBLE LIB(ZZZ) POSITION(*FIRST)** Where ZZZ = The new iDocs library name | Then place the new library on the first position on your library list: \\ **ADDLIBLE LIB(ZZZ) POSITION(*FIRST)** Where ZZZ = The new iDocs library name | ||
- | The next step is to copy over your form, check, and engine definitions. Use this Command to copy your information from your old FMG library to your new FMG library. Type the command **COPYDATA** and F4 to Prompt: \\ | + | The next step is to copy over your form, check, and engine definitions |
**COPYDATA** \\ | **COPYDATA** \\ | ||
\\ | \\ | ||
- | Note: //Make sure to use the correct library names on the To and FROM fields. | + | IMPORTANT: //Insure |
+ | < | ||
+ | Copy Data File (COPYDATA) | ||
+ | |||
+ | Type choices, press Enter. | ||
+ | |||
+ | From Library . . . . . . . . . . | ||
+ | To Library . . . . . . . . . . . | ||
+ | | ||
+ | | ||
+ | | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | | ||
+ | | ||
+ | | ||
+ | </ | ||
+ | |||
+ | __In version 6.91 we’ve added an additional parameter option on the COPYDATA command.__ | ||
+ | |||
+ | To create a directory use: MKDIR | ||
+ | Example: | ||
+ | < | ||
+ | C: | ||
+ | Create Directory (MKDIR) | ||
+ | |||
+ | Type choices, press Enter. | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | | ||
+ | + for more values | ||
+ | | ||
+ | | ||
+ | | ||
+ | </ | ||
+ | |||
+ | |||
+ | If you already are using iFax, before executing the COPYDATA command find out your COM port by going to a command line and typing in WRKLIND FAXCOM*. | ||
+ | |||
+ | This will display a list of current lines being used for your FAXCOM (most likely one line). | ||
Then verify that the data area contains the name of the library as installed on your system by using this Command: \\ | Then verify that the data area contains the name of the library as installed on your system by using this Command: \\ |
pub/installation_for_idocs_6.x.txt · Last modified: 2022/06/25 17:02 by 127.0.0.1