Differences

This shows you the differences between two versions of the page.

--- pub:imailappserver [2024/04/16 11:54] – [Start Applications Server] kkramer
+++ pub:imailappserver [2024/04/16 12:01] (current) – [Start Applications Server] kkramer
@@ Line 226: / Line 226: @@
 Enter the iMail Applications server, or prompt for a selection of available iMail Server Applications and select from the valid list. Next to the prompt for the iMail Job Queue, enter the specific job queue used to route the iMail Applications Server. \\
-Enter a Y to re-process RDY spool files. Default is N.**Revision iDOCS 8.0 04/09/24.**  \\
+Enter a Y to re-process RDY spool files. Default is N. **Added on Revision iDOCS 8.0 04/09/24.**  \\
 Benefits: If 'Y", after starting the engine, the administrator does not need to refresh the spool files alreading existing the the monitored output queue in *RDY status.
@@ Line 232: / Line 232: @@
 **Behavior when starting the iMail Server:**\\
 When "Re-process RDY spool file" is set to 'Y'
-  * Unordered List ItemSpool files in the monitored out queues that are in 'RDY' status will get processed.
+  * The server will process spool files in RDY status already in the out queue being monitored.
-  * Unordered List ItemSpool files in the monitored out queues that are in 'HLD' status will stay in the out queue and not be processed.
-  * Unordered List ItemSpool files introduced and that have been refreshed (hold/release) to 'RDY' status will get processed.
 When "Re-process RDY spool file" is set to 'N'
-  * Unordered List ItemSpool files in the monitored out queues that are in 'RDY' and 'HLD' status will not be processed.
+  * The server will only process spool files freshly introduced in *RDY status.
-  * Unordered List ItemSpool files introduced and that have been refreshed (hold/release) to 'RDY' status will get processed.
 **NOTE:** To utilize this function in a job scheduled entry use the following command to run:\\