You can make decisions to execute specific mapping instructions based on user defined “triggers” in the spool file
11/30/20 iDocs Form Suite FM2540C1
12:47:55 Map Field Maintenance KKRAMER
Form Name. . . . . . OFCONDI Field Name . . . BLOCK002
Description. . . Mapped Field Two
Map next field end of this field . . N (Y/N)
Conditionally Overlay . . CONDITWO.MAC F4=List Side *NONE F4=List
Conditionally Map
AND/OR Row From To Operator Value
Column Column
*CURROW 6 9 = Page
AND *CURROW 11 12 > 1
OR 1 1 1 <> 1
More...
F3=Exit F10=Save F12=Cancel
* If the value in column x to column y: Map this field only if the values specified exist in the columns specified, otherwise the field does not map.
| Mapped Field Conditional Tests | ||
|---|---|---|
| = | equal to | |
| <= | less than or equal to | |
| < | less than | |
| >= | greater than or equal to | |
| > | greater than | |
| <> | not equal to | |
Use caution with leading blanks in the comparison value field; do not enclose the test operator or the comparison value in quotes.
* *CURROW: Will automatically get the current row.
The Conditionally Overlay field can be utilized to conditionally display a macro on the simplex or duplex output form. *NONE = Is the default setting which is no condition value for the parameter When a macro file name is entered in the Conditionally Overlay field it will exclude the Mapped Field if the macro file value on the Form Application's Front Side Overlay or Back Side Overlay does not match with the value entered in the Conditionally Overlay field. The Conditionally Overlay field can be prompt with F4 to look up macro file name as shown below.
FM2525W1
Select an overlay
Type selection, press Enter
1=Select 5=Display
Search
Opt Overlay Type Description
*NONE FORM
_IMAP6T1 FORM
_IMAP6T5 FORM
_IMAP6T6 FORM
_IMAP6T7 FORM
#IMAP6T6 FORM
A FORM
AA FORM
AAA FORM
AAAA FORM +
F5=Refresh F12=Previous
The Side field can be used to select the side option for the macro file in the conditional setting. The Side field can be prompted with F4 to look up the side option for the macro file as shown below.
FM2549W1
Map Side
1=Select
Sel Side Description
*NONE Non Duplex field
*FRONT Front side duplex
*BACK Back side duplex
Bottom
F12=Previous